Below, how does the Outdoor Flood light manufacturer share the use of floodlights?
1. According to the actual needs of the work site, determine the installation position and mode of the lamp, and then prepare the corresponding length of Φ8 ~ Φ14mm three-core cable according to the distance from the lamp to the power contact.
2. Open the ballast end cover, loosen the compression nut of the ballast cable inlet, and introduce the lamp cable and power wire through the compression nut to the internal terminal of the ballast, connect and fix, respectively Tighten the cable tie nut and tighten the ballast end cap.
3. Install the lamp and ballast according to the determined installation position and mode, and then connect the other end of the ballast input cable to the 220V power supply according to the explosion-proof requirements.
4. Loosen the screw at the bottom of the lamp holder. Turn the lamp holder 360° to the left and right to adjust the illumination orientation. Loosen the screws on both sides of the lamp holder. Adjust the illumination angle of the lamp head up and down according to the lighting requirements, and then tighten the screws. When replacing the lamp, use a suitable screwdriver or other tool to insert the hole in the two raised parts on the side of the front cover, unscrew the front cover, remove the bad bulb, and replace the new one.
information about Outdoor Flood light
Loading
