Because plastic pellets are small in size, they are processed by molds. Generally, there are more than hundreds of fetches in one mold. If plastic pellet manufacturers use manual scissors to fetch products, the efficiency is very low, not only will increase the cost, The cut product will also have the same phenomenon of the same size of the glue position.
Plastic Balls Manufacture's cutting nozzle is usually cut by die cutting. It is necessary to open a set of knife molds, and then use pneumatic or hydraulic machines to remove the entire product. Not only is it efficient, but the cut product is also beautiful. The cut out positions for the glue feeding are the same size, which is convenient for post-processing.
Through the above introduction, Rubber Rings Wholesaler hopes that you can simply refer to the content of this article in future use.
Loading
